The Glass Incycler Rig is a collaboration between MiniNail and Slugworth Glass, hand blown in Colorado. Thick borosilicate, a 14mm female ground joint for an enail, and an incycler that sends its own water back down through itself.

Every colorway is its own piece of glass. Pick yours from the dropdown.

🔄 What an Incycler Does

Water climbing the neck on a hard pull is the thing that ends a session early. An incycler routes it back down through an inner chamber instead, so the water keeps cycling inside the rig rather than heading for your mouth.

Pull it as hard as you want. The chug stays where it belongs.

🎨 The Glass Work

Each rig carries encalmos, rings of color fused in at the joints where two sections of glass meet. Both sides are lip wrapped with a thin line of raven black, and a custom MiniNail dichro millie is set into the piece.

Because it is hand blown, no two come out identical. The colorway you order is the style, not a copy.

🔧 Built Around an Enail

The 14mm female joint is a banger hanger, angled to take a quartz banger or a hybrid nail with a 14mm male joint. The downstem is fused in, so there is nothing down there to work loose or get lost.

At 9 inches tall and about 4 inches wide, it stands taller and narrower than the Top Hat, on a base weighted for a rig that has a coil and a cable hanging off one side.

⚙️ Specifications

• Thick borosilicate glass
• Incycler recirculation
• 14mm female ground joint, banger hanger style
• Fixed downstem
• Slitted perc
• MiniNail dichro millie
• Encalmo color rings and raven black lip wraps
• Approximately 9 inches tall, 4 inches wide
• Hand blown in Colorado by Slugworth Glass

📦 What's Included

• 1× Glass Incycler Rig in the colorway you choose

Rig only. A nail or banger, heater coil and controller are sold separately.

🎯 What It Pairs With

• Quartz Banger 25mm - 14mm male, drops straight into this joint
• Quartz Hybrid Universal Nail - titanium body with a quartz dish, also 14mm
• Enail with Heater Coil - the controller and coil that heat either one
• Glass Top Hat Rig - the same glass work in a shorter rig with a slitted perc
• Silicone Reclaim Catcher - 14mm male, catches reclaim before it reaches the glass
• Glassware and Dab Rigs - the Top Hats, pucks and recyclers alongside this one

🧠 Pro Tips

• Fill to just above the perc slits. An incycler needs enough water to move, and too much of it just makes the recirculation work harder.
• Change the water often. It is the cheapest thing you can do for how a rig tastes.
• Keep the coil cable running off the back of the desk rather than across it. The cable is what pulls a rig over, not the rig.
• A fixed downstem cleans in place. Warm water and iso through the joint, cap both ends, shake, rinse.
• Give it a moment after a big pull before you tip it. There is water moving through the inner chamber for a second or two after you stop.