Flower
Wand
Desktop dry herb vaporizer powered by the Micro Enail Controller.
Safety Information
Read all three cards before first use. This device produces extreme heat by design.
Hot Surface
- The coil heats to extreme temperatures — up to a maximum of 1100°F.
- Grip the wand by its silicone handle only.
- Always store the wand on the Heater Stand.
Electrical
- Power the controller down whenever the device is unattended.
- Keep the device and cord away from water.
Read Before Use
- Keep away from flammable materials, children, and pets.
- For use by adults of legal age only.
What's in the Kit
Quick Start
Eight steps from box to first draw. One action per step.
-
1
Dock the wand
Insert the poker tool into the wand handle, then lock the wand onto the Heater Stand.
-
2
Connect — power off
With the controller power OFF, connect the Flower Wand (5-pin MiniXLR) and the power cord.
-
3
Attach the bowl
Choose the 14/18mm male or female adapter, attach it to the bowl, and connect to your rig. Skip this step for the glass bowl.
-
4
Power on & heat
Power on, set your temperature with the up/down arrows, and wait about 3 minutes to heat.
-
5
Fill the bowl
Loosely fill the bowl to the first ledge. If using the titanium bowl, make sure the titanium screen is installed.
-
6
Place the wand
Grab the wand by its handle and place it into the bowl.
-
7
Draw
Inhale gently — long, slow draws. Poke & pack between draws.
-
8
Finish & clear
Return the wand to the Heater Stand, then clear the bowl with a pull or the carb.
How It Works
Pure convection. Hot air does the work — the flower never touches the coil.
Air drawn in from above
As you inhale, fresh air enters through the top of the wand.
Heated at the coil
Quartz spheres at the coil bring the moving air to your set temperature.
Hot air passes over flower
The heated air flows evenly across the material in the bowl.
Vapor exits into your rig
Vapor leaves through the bottom of the bowl and into the rig.
Temperature & Controls
Tap a section to expand it.
Controller quick setup guide
Changing the set temperature
Use the up and down arrows on the controller to raise or lower the set temperature. The display shows your target; allow about 3 minutes for the coil to reach it after a change.
Advanced Menu
PRE — Temperature presets: save and recall your preferred settings.
OFF — Auto-timer: sets the controller to power down automatically.
HTR — Heater selection: BnR / HYR / FLOR. Set to FLOR for the Flower Wand.
TEP — Toggle the display between °F and °C.
Powering down
Allow roughly 10 minutes of cooldown after powering off. The coil stays hot after the display turns off — keep the wand on its Heater Stand until fully cool.