Micro
Enail
Desktop concentrate enail powered by the MiniNail Micro Enail Controller.
Safety Information
Read all three cards before first use. This device produces extreme heat by design.
Hot Surface
- The coil and nail heat to extreme temperatures — up to a maximum of 900°F.
- Never touch the coil or nail while the unit is in use.
- Allow a full cooldown before handling or moving the coil.
Electrical
- Power the controller down whenever the device is unattended.
- Keep the device and cord away from water.
Read Before Use
- Keep away from flammable materials, children, and pets.
- For use by adults of legal age only.
What's in the Kit
Quick Start
Eight steps from box to first dab. One action per step.
-
1
Set the station
Lay down the Slab Pad and set your rig and controller on it.
-
2
Connect — power off
With the controller power OFF, connect the Hybrid Heater Coil (5-pin MiniXLR) and the power cord. Plug into 3-prong wall outlet or power strip.
-
3
Attach the nail
Choose the male or female joint adapter and fit the nail to your rig.
-
4
Seat the coil
Wrap the Hybrid Heater Coil around the nail so it hugs the bottom and sidewalls of the dish.
-
5
Power on & heat
Power on, set your temperature with the up/down arrows, and wait about 3 minutes to heat. You will notice the temperature rising on the Controller Box display.
-
6
Load the dish
Place your concentrate into the dish with the dabber (dab tool).
-
7
Cap & inhale
Set the carb cap and inhale — the Cyclone Spin vortex keeps your concentrate moving in the dish.
-
8
Power down
When finished, power the controller down and let the coil and nail cool fully before handling.
How It Works
Precision conduction. The controller holds your exact temperature — the coil does the rest.
Controller sets the temperature
The Enail Controller Box holds your dish at the exact temperature you set — no torch, no guesswork.
Coil heats bottom and sidewalls
The Hybrid Heater Coil wraps the dish on two axes for even heat; especially effective at lower temperatures.
Dish vaporizes the concentrate
The pre-calibrated nail holds steady at the set point, vaporizing concentrate across the deep-dish surface.
Carb cap spins the vapor
Any of our carb cap styles create the Cyclone Spin vortex inside the dish, moving concentrate for better function with every draw.
Temperature & Controls
Tap a section to expand it.
Controller quick setup guide
Changing the set temperature
Use the up and down arrows on the controller to raise or lower the set temperature. The display shows your target; allow about 3 minutes for the coil to reach it after a change. International units display in °C by default.
Advanced Menu
PRE — Temperature presets: save and recall your preferred settings.
OFF — Auto-timer: sets the controller to power down automatically.
HTR — Heater selection: BnR / HYR / FLOR. Set to match your coil — HYR for the Hybrid Heater Coil, BnR for the banger coil.
TEP — Toggle the display between °F and °C.
Powering down
Allow roughly 10 minutes of cooldown after powering off. The coil and nail stay hot after the display turns off — keep hands clear until fully cool.