Tall Terp Slurper Set (14mm)

The Tall Terp Slurper Set is a complete quartz setup on a 14mm male joint: a tall slurper, a quartz pillar that turns inside the tube, and a quartz cap to seal the top.

📏 More Surface for Bigger Dabs

The taller tube is more hot quartz for your concentrate to vaporize against. That is what the height is for. Load a bigger dab and there is more surface working on it.

If you would rather sit lower on your rig, the standard Terp Slurper Set has the same dish and the same joint in a shorter body.

🌀 Three Slits Create the Spin

Three small slits are cut where the dish meets the quartz tube. With the cap on, that is the only way in, so every pull draws air through those slits and turns whatever is sitting in the tube.

The cap is not doing the spinning. Its job is to close the top so the air has to come through the slits instead.

💎 The Pillar Travels the Whole Tube

The included quartz pillar does not sit and spin in one spot. Air coming through the slits carries it up and down the tube, so it works the full 45mm of travel.

The tube also takes pearls, balls and other pillars if you want to run something different in there.

🔥 Heating It

The extra height all sits above the coil, so the base is the same as the standard set and it heats the same way. Set it into a Coil Caddy with either coil, the 30.2mm Hybrid Heater Coil or the 40mm XL, bring it up to temperature, then lift it onto your rig. No torch, and nothing attached to your glass.

⚙️ Specifications

• Pure quartz
• 14mm male joint, for a 14mm female rig
• 30mm wide at the base
• 79mm tall overall
• Middle tube 45mm tall, 9mm inside diameter
• Quartz cap 15mm inside diameter, 20mm outside diameter
• Quartz pillar 30mm tall
• Three slits where the dish meets the tube
• Full weld neck
• Chamfered rim, so a marble seats flush if you run one instead of the cap
• Works in the Coil Caddy with either coil, 30.2mm or 40mm XL

📦 What’s Included

• 1× Tall Quartz Terp Slurper, 14mm male joint
• 1× Quartz Pillar
• 1× Quartz Cap

The quartz set is complete. A Coil Caddy and a MiniNail controller are what heat it, and pearls are their own thing.

🎯 What It Pairs With

• Coil Caddy – the dock this slurper heats in
• Terp Pearls – run them in the tube alongside the pillar or on their own
• Solid Quartz Pillar – a spare, or a second one to swap in
• Ruby Pillar – denser than quartz, so it holds heat longer
• Coil Caddy Accessories – coils, screws and replacement parts
• Terp Slurpers – the standard height and the 10mm sets

🧠 Pro Tips

• Recommended range is 500 to 600°F.
• Nothing turning? Check the cap seal. The spin depends on the top being closed so air has to come through the slits.
• Swab the dish and the tube while they are still warm. Quartz gives residue plenty to hold onto once it cools.
• Give the quartz about 3 minutes in the caddy before the first dab of the session.