Terp Slurper Set (14mm)

The Terp Slurper Set is a complete quartz setup on a 14mm male joint: the slurper itself, a quartz pillar that turns inside the tube, and a quartz cap to seal the top.

🌀 Three Slits Create the Spin

Three small slits are cut where the dish meets the quartz tube. With the cap on, that is the only way in, so every pull draws air through those slits and turns whatever is sitting in the tube.

The cap is not doing the spinning. Its job is to close the top so the air has to come through the slits instead.

💎 The Pillar Travels the Whole Tube

The included quartz pillar does not sit and spin in one spot. Air coming through the slits carries it up and down the tube as it turns.

The tube also takes pearls, balls and other pillars if you want to run something different in there.

🔥 Heating It

Set it into a Coil Caddy with either coil, the 30.2mm Hybrid Heater Coil or the 40mm XL. The 30mm base comes up to temperature in the dock, then lifts out onto your rig. No torch, and nothing attached to your glass.

📏 There Is a Taller Version

The Tall Terp Slurper Set has the same dish and the same joint on a longer tube, which puts more hot quartz on a bigger dab. This one keeps the profile lower on your rig.

⚙️ Specifications

• Pure quartz
• 14mm male joint, for a 14mm female rig
• 30mm wide at the base
• 57mm tall overall
• Middle tube 30mm tall, 9mm inside diameter
• Quartz cap 15mm inside diameter, 20mm outside diameter
• Quartz pillar 30mm tall
• Three slits where the dish meets the tube
• Full weld neck
• Chamfered rim, so a marble seats flush if you run one instead of the cap
• Works in the Coil Caddy with either coil, 30.2mm or 40mm XL

📦 What’s Included

• 1× Quartz Terp Slurper, 14mm male joint
• 1× Quartz Pillar
• 1× Quartz Cap

The quartz set is complete. A Coil Caddy and a MiniNail controller are what heat it, and pearls are their own thing.

🎯 What It Pairs With

• Coil Caddy – the dock this slurper heats in
• Terp Pearls – run them in the tube alongside the pillar or on their own
• Solid Quartz Pillar – a spare, or a second one to swap in
• Ruby Pillar – denser than quartz, so it holds heat longer
• Coil Caddy Accessories – coils, screws and replacement parts
• Terp Slurpers – the tall version and the 10mm sets

🧠 Pro Tips

• Recommended range is 500 to 600°F.
• Nothing turning? Check the cap seal. The spin depends on the top being closed so air has to come through the slits.
• Swab the dish and the tube while they are still warm. Quartz gives residue plenty to hold onto once it cools.
• Give the quartz about 3 minutes in the caddy before the first dab of the session.