Slugger Tube Rig

The Slugger Tube Rig is a collaboration between MiniNail and Slugworth Glass, hand blown in Colorado. A classic straight tube in thick borosilicate, 13 inches tall, on a heavy base.

Every colorway is its own piece of glass. Pick yours from the dropdown.

🌿 Built for the Flower Wand

The 14mm female joint takes a MiniNail flower bowl, and the Flower Wand sits on top of it. That is what this rig was drawn around.

The height is the reason. At 13 inches there is a long straight run between the bowl and your mouth, and vapor cools on the way up.

It runs a banger or a hybrid nail just as well if you want to dab on it.

🎨 The Glass Work

Each rig carries encalmos, rings of color fused in at the joints where two sections of glass meet. Both sides are lip wrapped with a thin line of raven black, and a custom MiniNail dichro millie is set into the piece.

Because it is hand blown, no two come out identical. The colorway you order is the style, not a copy.

🔧 The Downstem Comes Out

Unlike the Top Hat and the Incycler, this one has a removable glass downstem. It lifts out for cleaning, and it can be replaced on its own if it ever goes.

⚙️ Specifications

• Thick borosilicate glass
• Classic straight tube design
• 14mm female ground joint
• Removable glass downstem
• MiniNail dichro millie
• Encalmo color rings and raven black lip wraps
• Approximately 13 inches tall, 4 inches wide
• Hand blown in Colorado by Slugworth Glass

📦 What’s Included

• 1× Slugger Tube Rig in the colorway you choose
• 1× Removable glass downstem

Rig only. A flower bowl, wand, nail, heater coil and controller are sold separately.

🎯 What It Pairs With

• Flower Wand Ball Vape Kit – the wand this rig was built around
• Flower Bowls – glass, titanium, wood and quartz, in 14mm
• Keep It Fluffy Grinder – an airy grind packs a bowl better
• Quartz Banger 25mm – 14mm male, if you want to dab on it too
• Glass Top Hat Rig – the same glass work in a short dab rig with a slitted perc
• Glassware and Dab Rigs – the Top Hats, incyclers and pucks alongside this one

🧠 Pro Tips

• Fill until the downstem slits are just covered. A tube gives water a long way to travel, and overfilling is how it reaches the mouthpiece.
• Pull the downstem out when you clean. That is the part that gets the worst of it and the reason it is removable.
• Change the water often. It is the cheapest thing you can do for how a rig tastes.
• Keep the wand cable running off the back of the desk rather than across it. The cable is what pulls a rig over, not the rig.
• A tall tube wants a flat spot. Thirteen inches of glass on a sloped mat is a bad combination.