25mm Quartz Banger w/ 10mm Joint

The 25mm Quartz Banger w/ 10mm Joint is the standard 25mm bucket on a 10mm male joint, for rigs with a 10mm female connection. Low, consistent heat means your concentrate vaporizes off the surface instead of pooling and cooling the way it does under a torch.

Pure quartz throughout, with a 5mm base and 3mm walls. That mass is what holds temperature through a low-temp dab, which is where flavor lives.

🔎 Same Bucket, Different Joint

This is the same 25mm dish as the Quartz Banger 25mm and it takes the same Hybrid Heater Coil (Standard Size). The only difference is the joint: 10mm male instead of 14mm.

Check your rig before you order. A 10mm female joint takes this one; a 14mm female joint takes the standard version.

🔩 The Quartz Post

Every MiniNail banger has a straight quartz post on the neck. Your heater coil seats against it, and the included Magnetic Tie anchors to it.

The result is a coil that sits where you put it and a banger that stays put with it. Generic quartz has no post, so the coil is free to shift.

⚙️ Specifications

• 25mm bucket – built for the standard Hybrid Heater Coil
• 10mm male joint – fits a 10mm female glass joint
• 5mm extra-thick base for heat retention at low temperatures
• 3mm extra-thick quartz walls
• Flat top with a chamfered edge, so bubble caps seat properly
• Straight quartz post for MiniNail heater coils
• Pure quartz

📦 What’s Included

• 25mm Quartz Banger with 10mm male joint
• Magnetic Tie

🎯 What It Pairs With

• Hybrid Heater Coil (Standard Size) – wraps the bottom and sidewalls, not just one band
• Glass Bubble Cap – turn it to steer the air across the dish
• Glass Cyclone Carb Cap – two ports that spin the air into a vortex
• Flat Tip Dabber and Carb Cap – dabber and cap in one tool
• Terp pearls – 6mm suits a 25mm bucket

🧠 Pro Tips

• Recommended range is 500 to 600°F. Give the quartz about 3 minutes to come up to temperature.
• Swab the dish while it is still warm – residue lifts out easily then and takes real work later.
• Rig with an angled joint? The 45° bend version keeps the bucket level on a tube rig.
• Want a bigger dish? The 30mm XL takes the 30mm XL coil instead.