MiniNail x BMG Quartz Globstopper Banger (10mm)

The Quartz Globstopper Banger is a collaboration between MiniNail and Black Market Glass. A 25mm quartz bucket on a 10mm male joint, with a ground joint and seven intakes.

🔧 A Full Bucket on a 10mm Joint

The bucket is the same 25mm as the 14mm version. Only the joint is smaller.

That is the point of this one. If your rig has a 10mm female, this is the Globstopper that fits it, with the same bucket and the same seven intakes.

🌀 Seven Intakes

Seven intake holes are cut around the bucket. Air comes in from seven points at once rather than from a single side, so the draw pulls evenly all the way around.

That even pull is what drives the rotation. Cap it and the air turns, a pearl turns with it, and your concentrate keeps moving across the quartz instead of sitting in one place and burning off where the heat is.

💎 Full Quartz, Ground Joint

Quartz through the whole piece, made in Portland, Oregon. The ground joint is cut by Parbilt Glass, so it seats into a 10mm female without tape, without an adapter and without play, and it goes on and off cleanly every time.

⚠️ Takes the Standard Hybrid Coil

The 25mm bucket is sized for the Hybrid Heater Coil, the standard size coil. It is not built around the 30mm XL coil.

Check the joint on your rig too. This is the 10mm male version.

⚙️ Specifications

• Full quartz construction
• 25mm bucket
• 10mm male joint
• Seven intakes
• Ground joint cut by Parbilt Glass
• Sized for the standard 25mm Hybrid Heater Coil
• A MiniNail and Black Market Glass collaboration
• Made in Portland, Oregon

📦 What’s Included

• 1× Quartz Globstopper Banger, 25mm with a 10mm male joint

Banger only. A controller, heater coil, carb cap and pearls are sold separately.

🎯 What It Pairs With

• Hybrid Heater Coil (Standard Size) – the coil this bucket is sized for
• Globstopper Banger, 14mm Joint – the same banger for a 14mm rig
• Glass Cyclone Carb Cap – two ports that spin the air into a vortex
• Terp Pearls – the seven intakes are what keep them turning
• Magnetic Tie – holds the coil snug against the banger
• Heater Coil Stand – somewhere to set hot quartz down

🧠 Pro Tips

• Recommended range is 500 to 600°F. Give the quartz a few minutes to come up before the first dab of the session.
• Swab the bucket while it is still warm. Quartz gives residue plenty to hold onto once it cools.
• Cap it before the airflow matters. The seven intakes only do their job once the cap is on and you are pulling.
• Seat the ground joint gently and give it a small twist. It is cut to fit, so it does not need forcing.