Glass Top Hat Rig

The Glass Top Hat Rig is a collaboration between MiniNail and Slugworth Glass, hand blown in Colorado. Thick borosilicate on a wide, heavy base, with a 14mm female ground joint sized for an enail.

Every colorway is its own piece of glass. Pick yours from the dropdown.

🎨 The Glass Work

Each rig carries encalmos, rings of color fused in at the joints where two sections of glass meet. Both sides are lip wrapped with a thin line of raven black, and a custom MiniNail dichro millie is set into the piece.

Because it is hand blown, no two come out identical. The colorway you order is the style, not a copy.

💧 Slitted Perc, Fixed Downstem

The downstem is fused in rather than removable, so there is no ground joint down there to work loose or get lost. It feeds a slitted perc that breaks the pull up before it reaches you.

🔧 Built Around an Enail

The 14mm female joint is a banger hanger, angled to take a quartz banger or a hybrid nail with a 14mm male joint. The base is wide and heavy on purpose, because a rig running an enail has a coil, a cable and a hot nail hanging off one side of it.

At 8 inches tall and about 5 inches wide, it sits low enough to reach across a desk without standing up.

⚙️ Specifications

• Thick borosilicate glass
• 14mm female ground joint, banger hanger style
• Fixed downstem
• Slitted perc
• MiniNail dichro millie
• Encalmo color rings and raven black lip wraps
• Approximately 8 inches tall, 5 inches wide
• Hand blown in Colorado by Slugworth Glass

📦 What’s Included

• 1× Glass Top Hat Rig in the colorway you choose

Rig only. A nail or banger, heater coil and controller are sold separately.

🎯 What It Pairs With

• Quartz Banger 25mm – 14mm male, drops straight into this joint
• Quartz Hybrid Universal Nail – titanium body with a quartz dish, also 14mm
• Enail with Heater Coil – the controller and coil that heat either one
• Silicone Reclaim Catcher – 14mm male, catches reclaim before it reaches the glass
• Slab Pad Dab Mat – something soft under the base
• Glassware and Dab Rigs – the incyclers, pucks and recyclers alongside this one

🧠 Pro Tips

• Fill to just above the perc slits. Too much water and you pull it up the neck, too little and the perc is not doing anything.
• Change the water often. It is the cheapest thing you can do for how a rig tastes.
• Keep the coil cable running off the back of the desk rather than across it. The cable is what pulls a rig over, not the rig.
• A fixed downstem cleans in place. Warm water and iso through the joint, cap both ends, shake, rinse.