25mm Quartz Banger w/ 10mm Joint (45° Bend)

The 25mm Quartz Banger w/ 10mm Joint (45° Bend) is built for rigs with an angled joint. The bend cancels out the angle so the bucket sits level, and your concentrate stays in the dish instead of running toward one wall.

Pure quartz throughout, with a 5mm base and 3mm walls. That mass is what holds temperature through a low-temp dab, which is where flavor lives.

📐 Why the Bend

Tube rigs and most angled-joint rigs put the joint on a slant. A straight banger on a slanted joint means a slanted bucket. The 45° bend brings it back to level.

If your rig has a straight vertical joint, you want the straight 10mm version instead.

🔩 The Quartz Post

Every MiniNail banger has a straight quartz post on the neck. Your Hybrid Heater Coil (Standard Size) seats against it, and the included Magnetic Tie anchors to it.

The result is a coil that sits where you put it and a banger that stays put with it. Generic quartz has no post, so the coil is free to shift.

⚙️ Specifications

• 25mm bucket – built for the standard Hybrid Heater Coil
• 10mm male joint – fits a 10mm female glass joint
• 45° bend to level the bucket on an angled joint
• 5mm extra-thick base for heat retention at low temperatures
• 3mm extra-thick quartz walls
• Flat top with a chamfered edge, so bubble caps seat properly
• Straight quartz post for MiniNail heater coils
• Pure quartz

📦 What’s Included

• 25mm Quartz Banger, 10mm male joint, 45° bend
• Magnetic Tie

🎯 What It Pairs With

• Hybrid Heater Coil (Standard Size) – wraps the bottom and sidewalls, not just one band
• Glass Bubble Cap – turn it to steer the air across the dish
• Glass Cyclone Carb Cap – two ports that spin the air into a vortex
• Flat Tip Dabber and Carb Cap – dabber and cap in one tool
• Terp pearls – 6mm suits a 25mm bucket

🧠 Pro Tips

• Recommended range is 500 to 600°F. Give the quartz about 3 minutes to come up to temperature.
• Swab the dish while it is still warm – residue lifts out easily then and takes real work later.
• The bend puts the bucket further from the rig, so leave yourself room for the coil and cable before you seat it.