MiniNail Quartz Hybrid Nail Instructions & Assembly

The MiniNail Quartz Hybrid Nail assembles in three steps. Below are the written instructions plus the reference diagram. If you are setting up a full kit for the first time, start with the MiniNail Enail User Manual.

How to assemble your Quartz Hybrid Nail

  1. Pick your adapter and attach it to the heat shield. Choose the male or female Hybrid Nail Adapter that fits your rig. Male adapters cover 10mm, 14mm and 18mm joints; female adapters cover 14mm and 18mm. For a 10mm joint, use the 10mm Hybrid Nail Adapter.
  2. Fit your coil. A Hybrid Heater Coil needs no adapter, so skip straight to step 3. If you are running a barrel coil, place the matching 16mm or 20mm barrel coil adapter inside the coil, sitting on top of step 1. Barrel coil adapters are sold separately.
  3. Attach the dish with the screw. Fit your quartz or titanium dish to the assembly using the screw. Tighten it loosely only. Overtightening is the most common cause of a cracked quartz dish.

Fully assembled, the coil should sit snug against the bottom and sidewalls of the dish. That two-axis contact is what lets the hybrid design hold temperature at lower settings.

Reference diagram

MiniNail Quartz Hybrid Nail assembly instructions: adapter, heat shield, coil and dish

Parts and replacements